– 40k Heroic scale
– 25mm bases
– Sculpted by Red Pilgrim 


SKU: RPM_21021890 Category:


IMPORTANT! This set allows you to build DESERT HAWKS JANISSARIES CORPS. They are veterans of the Desert Hawks, so they are more heavily armed and can perform more difficult tasks on the battlefield. The set includes five JANISSARIES, two with RIFLES, a SERGEANT with a POWER SWORD and a BOLT PISTOL, a VETERAN with a VOLLEY GUN and a SPECIALIST with PLASMA GUN. Rifles can be attached to any of them, you just need to cut off the locks.


The Janissaries Corps is recruited from the veterans of the Desert Hawks, the most experienced and battle-hardened warriors. The Janissaries are armed with advanced las-rifles, clad in carapace armor and operate in the most difficult directions. In the battles on the al-Qadam foothold, The Janissaries held back the attack of the mechanized formations of the Heresiarch for two weeks, and despite the numerical and technical superiority of the enemy, they did not allow him to break through to the shrines of Kaladan. The relics were saved, and the Janissaries once again fanned themselves with immortal glory.


Each of them consists of the following parts: head, torso, legs, arms with weapons.


HQ resin miniature in 40k Heroic scale with 25mm bases.
The miniatures require painting and assembly (use cyanoacrylate superglue only).



– 8K ultra-high resolution 3D printing with the market-top printers guarantees the highest possible print quality for today;
– The best UV printing resin maximizes the survival of models even after falling off the table;
– Careful manual parts positioning by our experienced specialists provide sharp printing with a minimum of the supports and makes post-processing fun and easy;



1. Check

Firstly, check out all the details whether there are no missing or miscast parts.
If you have problems with details – please contact us at [email protected].

2. Supports & touchpoints

We sell our 3D printed models without any major supports, but you should remove small touchpoints and ultra-tiny supports left on the model.
Please use a model knife and fine sandpaper.
Don’t be intimidated by the process, we use a top-quality UV printing resin and it is very easy to work with.

3. Warped Parts and Repositioning

Sometimes thinner parts could be slightly bent or twisted.
You can easily fix that by immersing the piece in hot water or by applying heat from a hairdryer.
The piece should reform to its original shape by itself.
If not, gently twist the piece back into position.
The amount of heat that needs to be applied is often determined by the thickness of the parts. Thicker parts need to be heated for a longer time.
This technique can also be used to bend some parts into shapes and positions to pose models.



We don’t collect any taxes or fees on your behalf, so you may pay the customs fees according to the law of your country while collecting the package.


There are no reviews yet.


Your email address will not be published. Required fields are marked *

Add to cart