IMPERIAL JOAN OF ST CLAIR

Description

IMPORTANT! This set allows you to build IMPERIAL LORD INTERROGATOR.

 

When the defenses of Kelemkar collapsed and the forces of the Heresiarch attacked the defenseless metropolis, the only place where the townspeople could find refuge was the stronghold of the monastery of St. Clair. The ancient fortress was home to the Sacramental Sisters, whose prayers had unusual healing powers. However, prayers alone could not stop the enemy and the inhabitants of St. Clair took up arms. The defense of the stronghold was led by the Elder Canon Joan Abatemalco, dressed in the ancient noble armor “Antioch” and armed with a consecrated power sword and the “Righteous” fire system. Her courage and valor were in no way inferior to the strong walls of the monastery, and in the end the enemy was forced to lift the siege and retreat.

 

HQ resin miniature in 40k Heroic scale with 60mm base.
The miniatures require painting and assembly (use cyanoacrylate superglue only).

 

WE NEVER COMPROMISE ON QUALITY

– 8K ultra-high resolution 3D printing with the market-top printers guarantees the highest possible print quality for today;
– The best UV printing resin maximizes the survival of models even after falling off the table;
– Careful manual parts positioning by our experienced specialists provide sharp printing with a minimum of the supports and makes post-processing fun and easy;

 

PREPARATION

1. Check

Firstly, check out all the details whether there are no missing or miscast parts.
If you have problems with details – please contact us at [email protected].

2. Supports & touchpoints

We sell our 3D printed models without any major supports, but you should remove small touchpoints and ultra-tiny supports left on the model.
Please use a model knife and fine sandpaper.
Don’t be intimidated by the process, we use a top-quality UV printing resin and it is very easy to work with.

3. Warped Parts and Repositioning

Sometimes thinner parts could be slightly bent or twisted.
You can easily fix that by immersing the piece in hot water or by applying heat from a hairdryer.
The piece should reform to its original shape by itself.
If not, gently twist the piece back into position.
The amount of heat that needs to be applied is often determined by the thickness of the parts. Thicker parts need to be heated for a longer time.
This technique can also be used to bend some parts into shapes and positions to pose models.

 

---

 

We don’t collect any taxes or fees on your behalf, so you may pay the customs fees according to the law of your country while collecting the package.